Re: [Healeys] gap

[Per Schoerner <healeyguy@bredband.net>]

Hi
I'd say it depends on how much you want the engine to rev when you 
enrichen the carburettors, e.g. use the choke.
Per in Sweden

healey.nut@gmail.com skrev 2012-05-26 17:15:
> There's no real set here because it depends on how the throttle shaft has been 
> drilled.  Usually, however, I back off touching the lever by about one full 
> turn (after slow idle fully set).
>
> ------Original Message------
> From: Dr. C. Rubino
> Sender: healeys-bounces@autox.team.net
> To: healeylist
> Subject: [Healeys] gap
> Sent: May 26, 2012 22:54
>
> What size should the gap be between the fast idling screw and the throttle
> shaft lever?
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys

Unsubscribe/Manage: 
http://autox.team.net/mailman/options/healeys/mharc@autox.team.net