Hi Larry,
I've contacted John and although they have the standard round pattern
trims they cannot get material for the elliptical pattern.
I'm working on a plan to produce a small quantity of the material but it is
going to be a little costly!!
I want to find a sample of the original to work from.
Unfortunately I tend to become a little anal about these things but...there
is only 1 "RIGHT"
--
Michael Salter
I have BJ8 water pump kits
On Thu, May 3, 2012 at 4:39 PM, Larry Varley <varley at cosmos.net.au> wrote:
> Hi Mike, it may be worth a call to Greg at Kilmartins, in fact I have to
> call him today about my chassis, so I'll check for you.
> Cheers
> Larry
>
>
> On 3/05/2012 11:29 PM, Michael Salter wrote:
>
>> Oh wise ones,
>> I'm looking for a set of hens teeth..
>> Early 100s had alloy door trims made from aluminum sheet with a pattern of
>> elliptical rather than round impressions.
>> Does anyone know if this material is available?
|