Thanks. My only existing plug is on my car. I hate to lose all my fresh
oil. I did try to anneal the existing washer without much success. That's
why I am going to try to do a quick switch with my finger in the dike so to
speak.
Ron
----- Original Message -----
From: "john spaur" <jmsdarch at sbcglobal.net>
To: "Ron Fine" <RonFineEsq at earthlink.net>
Cc: <healeys at autox.team.net>
Sent: Friday, April 27, 2012 11:41 AM
Subject: Re: [Healeys] Oil plug washer
> 25/32" ID, 1-3/32 OD, .06 thick. Take your plug down to the hardware
> store.
>
> John
>
> At 06:03 PM 4/27/2012 +0000, Bob Spidell wrote:
>>I think it's 3/4" ID (hopefully, someone can un/confirm).
>>
>>Or, you can just anneal the one you have: heat it to 'cherry red' with a
>>propane torch and let cool. Will seal as good as new.
>>
>>
>>Bob
>>
>>
>>--------------------------------
>>Bob Spidell - San Jose, CA
>>
>>----- Original Message -----
>>
>>
>>Can someone give me the dimensions for the copper washer used to seal the
>>oil
>>drain plug on BN7? I need a new one and don't have time to order from
>>Moss.
>>I assume I can get one of the proper size locally.
>>
>>Thanks,
>>
>>Ron Fine
>>_______________________________________________
>>Support Team.Net http://www.team.net/donate.html
>>Suggested annual donation $12.75
>>Archive: http://www.team.net/archive
>>Forums: http://www.team.net/forums
>>
>>Healeys at autox.team.net
>>http://autox.team.net/mailman/listinfo/healeys
>>
>>Unsubscribe/Manage:
>>http://autox.team.net/mailman/options/healeys/jmsdarch at sbcglobal.net
|