You pretty much want it to stay on.
On 4/11/2012 5:12 PM, Williams, Allen wrote:
> Holy Cow! I knew it was hard to get off.
> Thanks
>
> ________________________________________
> From: Bob Spidell [bspidell at comcast.net]
> Sent: Wednesday, April 11, 2012 7:01 PM
> To: Williams, Allen
> Cc: healeys at autox.team.net
> Subject: Re: [Healeys] Torque spec for BJ7 rear hub nut
>
> 140 lb-ft
>
>
> On 4/11/2012 4:29 PM, Williams, Allen wrote:
>> Can anyone tell me the correct torque, if any, for the large thin nut that
>> holds the rear hub(bearing carrier)and bearing to the BJ7 axle? I've replaced
--
*******************************************************************
Bob Spidell San Jose, CA bspidell at comcast.net
*******************************************************************
|