Tim,
Remove plugs.
Use the starter solenoid button that faces rearward reachable from under
bonnet. You can use this to bump the engine with the starter.
Warm Regards,
Tracy Drummond
PMP | ITIL Service Manager | CISSP | bighealey at charter.net | 408-394-3444
cell | 408-776-0133 home | http://www.linkedin.com/in/tracydrummond
-----Original Message-----
From: healeys-bounces at autox.team.net [mailto:healeys-bounces at
autox.team.net]
On Behalf Of Tim Ward
Sent: Saturday, March 03, 2012 4:46 AM
To: 'AH Mail List'
Subject: [Healeys] Adjusting Valve Rocker Clearance
Hi Team
Once again I need the benefit of your collective wisdom.
I need to set the gaps again after a few years of use. I shall take out the
spark plugs so there is no resistance to turning the engine.
However.
The nut at the front, which is very large (I do have a spanner that size,
but the nut is too close to the chassis to use) also has a claw type fitting
on the front. So my question is, what is the easiest way to turn the engine
clockwise so that I get each successive valve, in the order set down in the
Haynes manual, to adjust? Using the starter is very imprecise. Rolling the
car in gear needs more space than I have in my garage, and is also quite
difficult to get precise. Is the claw fitting designed to be used by
something to turn the crank? If so what?
Thank you. I am sure that I shall get lots of help, as usual.
Tim
BJ8 '67
Tim Ward
Warwick House
12 Mill Road
Kislingbury
NN7 4BB
Tel: 07855 388 751
www.sixsigmaworks.co.uk
www.Shuttermagic.co.uk
www.kislingburyonline.co.uk
[demime 1.01d removed an attachment of type image/jpeg which had a name of
image001.jpg] _______________________________________________
Support Team.Net http://www.team.net/donate.html Suggested annual donation
$12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/bighealey at charter.net
|