Do not use thread locker. Tighten the studs hand tight. Use oil. But first,
make sure the threads on the studs are clean and without any burrs. Same thing
goes for the threads in the block.
Richard Mayor
BN7L-466 Vintage Racer
Portland, Oregon
> Date: Thu, 9 Feb 2012 22:24:40 -0800
> To: healeys@autox.team.net
> From: jmsdarch@sbcglobal.net
> Subject: [Healeys] Main bearing studs
>
> Are people using Loctite on the stud to block threads? If so red or blue?
>
> When the studs were removed from the block they seemed very loose
> because the stud would often turn before the locknut.
>
> Thank you,
> John Spaur
> San Jose
> MK II
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/mayorrichard@hotmail.com
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|