I used to rebuild them but the special bearing went out of production and
modfying the hardened shaft on the recommended replacement added so much
time that the cost of the parts and the time required to do the job made it
not worthwhile.I still have a pile of the replacement bearings and some
seals I think...You have to be very careful when using a press to
disassemble the pmp BTW. it is very easy to break the impellor.
--
Michael Salter
Check My Blog
http://www.netbug.net/blogmichael/
On Fri, Feb 10, 2012 at 7:47 AM, Richard Kahn <tahoehealey@hotmail.com>wrote:
> I asked this a long while ago but lost the reference to it. I am in need
> of a
> rebuild on a BJ8 Phase I water pump. I am using a County replacement from
> India but I'd like to carry a spare as I don't trust it.
> Who rebuilds these things? Or where can I get the parts to rebuild it
> myself?
> Thanks,
> Rich Kahn
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|