Hi,
I need to drill the holes in the new (kilmartin) floorboard for the seat
spacers and rails. I measured on another Healey nearby but would love some
more data points as this is quite a definitive operation.
Across the width of the car I currently have from the middle line of the car to
center of the front hole of the inner rail: 7 7/8" or from the propshaft tunnel
to the center of hole: 5" and in the length direction from the rear bulkhead
to the center of the rear hole: 8 1/2". From there I can deduct all other
hole locations. This just seems a bit too much forward.
thanks,
Bert
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|