Hi Richard, I have done a couple of these, making LHD into RHD steering
boxes. You will have to find a method of stopping the top felt bush sliding
down the new tube. First tin the last inch of tube with soft solder using a
gas torch very lightly. Use Liberal amounts of solder flux in the housing.
Housing in a vice tube hole side up. Sit the tube on the hole and carefully
heat the outside of the housing until the tube slides in under it's own
weight. Then run a little extra solder around the joint to finish off.
Cheers, Larry Varley
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of richard mayor
Sent: Thursday, 15 December 2011 1:29 PM
To: healeys
Subject: [Healeys] Steering column outer tube replacment - help
I need some advise about replacing a damaged outer steering column tube. I
have some new 4130 tubing, .059" wall thickness - same size as original. It
appears to me that the tubing is soldered into the steering box. Has anyone
replaced this tube? Any tips or suggestions on making this a smooth fix will
be greatly appreciated. I have sweated many copper plumbing joints together
quite nicely, but this job is a bit more challenging.
Richard Mayor
BN7L-466 Vintage Racer
Portland, Oregon
$12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/varley@cosmos.net.au
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|