As far as I am concerned it is just cleaning vinegar. That is what I use
now since the old stuff was used up. Rinse well with water afterwards.
Kees Oudesluijs
NL
Op 17-11-2011 19:17, BJ8 Healeys schreef:
> The Colortune kit instructions caution against leaving the parts installed
> too long because of the heat. I've found that they hold up just fine for
> the amount of time it takes to adjust both carburetors.
>
> Can anyone who has the kit tell me what the chemical is that is used to
> clean the spark plug view window? Mine is so old that the label on the
> bottle is no longer legible.
>
> Steve Byers
> HBJ8L/36666
> BJ8 Registry
> Havelock, NC USA
>
> -----Original Message-----
> From: healeys-bounces at autox.team.net [mailto:healeys-bounces at
> autox.team.net]
> On Behalf Of Tom
> Sent: Thursday, November 17, 2011 11:45 AM
> To: Richard Kahn
> Cc: healeys at autox.team.net
> Subject: Re: [Healeys] Gunson Colortune
>
> I found the plastic tube that holds the mirror will melt if you leave it in
> place too long. Now I use an old Heathkit gas analyzer I bought off Ebay.
> BJ8's separate the exhaust gases, so I measure the richness at the pipe of
> the carb I'm adjusting.
>
> - Tom
> _______________________________________________
> Healeys at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/coudesluijs
> at chello.nl
>
>
> -----
> Geen virus gevonden in dit bericht.
> Gecontroleerd door AVG - www.avg.com
> Versie: 2012.0.1872 / Virusdatabase: 2092/4622 - datum van uitgifte: 11/17/11
|