healeys
[Top] [All Lists]

[Healeys] Rear Hub Bearing

Subject: [Healeys] Rear Hub Bearing
From: mayorrichard at hotmail.com (richard mayor)
Date: Sun, 13 Nov 2011 02:34:42 +0000
References: <6D5A335A-9F91-4EEA-BD07-6A7A7E5E8514@pt.lu>
I doubt that it is a worn bearing. These bearings never seem to wear out. What
usually happens (for whatever reason) is that hub gets loose and the inside
spacer ring (it may be called a "distance piece")  no longer pinches the
bearing properly so that the outer race of the bearing then begins to spin in
the hub. This allows the outer bearing race to grind itself deeper into the
hub. The spacer ring is now useless and the hub can rock. If the bearing has
not gone too deep, you can drive out the studs and machine the face of the
hub. The ring is supposed to stand proud of the hub, with the gasket in place,
about .002" or .003". Check the manual on this for the exact amount. If the
bearing is too deep into the hub then you must replace the hub. You may also
have to use a bearing retaining compound to install the bearing into the hub
as it may no longer be a snug fit.

Richard Mayor
BN7L-466  Vintage Racer
Portland, Oregon


> From: pieters at pt.lu
> Date: Sat, 12 Nov 2011 21:24:02 +0100
> To: healeys at autox.team.net
> Subject: [Healeys] Rear Hub Bearing
>
> I am looking to verify a diagnosis. I am running rear disc brakes and have
> developed a rythmic clicking noise from the right rear that stops when the
> brakes are applied lightly.  I thought I had a warped disc and the noise
was
> the disc slapping the brake pad on each rotation. I jacked up the rear and
> found I could move both rear wheels in and out slightly but the right rear
I
> can "rock" . That is if I grab the front and rear of the tyre I can pull
the
> front out and rear in and vice versa. Rims are near new and the splines are
in
> good condition. The wheel spinners were of course tight.
>
>  I suspect it is wear in the hub bearing as I have disassembled the right
rear
> and can find nothing else broken or worn. The bearing runs quietly but
there
> is some in out play.
>
>  It there anything else I should be checking before I order new bearing
etc?
>
>  Thanks
> Pieter
> _______________________________________________
> Healeys at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/mayorrichard at hotmail.com

<Prev in Thread] Current Thread [Next in Thread>