I did this last weekend on my BJ8. Fitted new calipers, new fluid
canister, new booster, rebuilt brake master cyl, and replaced all pads
& linings. All were dry.
Just takes a little longer to bleed, and I had the car up on a hoist,
which made it far easier.
Chris
Sent from my iPhone
On 04/11/2011, at 3:47 AM, Richard Kahn <tahoehealey@hotmail.com> wrote:
> I have installed new clutch and brake master cylinders forgetting to
> bench
> bleed first. Can it be done now on the car (BJ8)? I have a Mityvac
> (sorry for
> spelling). Can I draw brake fluid from the car's reservoir into the
> cylinders
> successfully at the out ports and get rid of the air? If I need to
> remove the
> cylinder to bench bleed where can I get the correct sized fittings
> to connect
> clear tubes to the masters? Sorry for such a basic question but I
> couldn't
> find the Sim's sight which would probably tell me everything.
> Thanks
> Rich Kahn
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
>http://autox.team.net/mailman/options/healeys/austin.healey@gmail.com
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|