Mitch,
As stated many times before, (plus it's probably noted in the archives)
there is a chassis diagram for your model in the Body section of the
original workshop manual. The top surfaces of the outriggers are all on the
exact flat plane as the top of the chassis rails. The inner wall surface of
the inner sills sit on the ends of the outriggers which are stepped on the
ends to receive the sills. The top surface of the inner sill is 3" above
that of the top surface of the chassis, outriggers and therefore floors.
That and many other dimensions are noted on the diagram. It's in fine print
so you may want to copy and enlarge the diagram to see everything easier.
Rich
-----Original Message-----
From: healeys-bounces at autox.team.net [mailto:healeys-bounces at
autox.team.net]
On Behalf Of caddi5 at comcast.net
Sent: 2011-09-14 6:09
To: healeys at autox.team.net
Subject: [Healeys] inner sill replacement
Hello,
I am finally installing the inner sills on my 59 bn4............anyone have
detailed pictures,measurements.....I am having problems ....sill appears to
high.......I have the frame sitting on sawhorses positioned as Rich said
(just in front of front outrigger 6" and just behind rear outrigger 6")
frame is level .....end of outriggers are level to each other.........but
the end of outriggers to frame rails seem to be 1/2" high?? both of
them.............I am using kilmartin sills.............I am lost... any
help would be gratefully accepted!!!
frame/chassis is stripped down ...NO
engine,suspension,doors,fenders,shrouds,etc...........
Mitch Simmons
59 bn4
_______________________________________________
Healeys at autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/richchrysler at quickclic.net
|