Did you check the thickness of the shim on the main bearing. The one that is
sandwiched between the o/d adaptor plate and the bearing. If it is too thick
it will lock up the whole assembly.
Magnus Karlsson
www.concourshealeys.com
30 aug 2011 kl. 03:55 skrev john spaur:
> The overdrive has not been operated for several years but worked before
replacing a few parts. The OD and transmission worked freely before mating the
two together. Everything lined up fine and they slipped together without
forcing anything.
>
> After bolting the trans and OD together the OD will not move and when the
transmission is in gear it will not move either. All I could garner from the
archives is that the OD brake ring or clutch assembly might be locked due to
weak clutch springs. They were a little shorter than spec.
>
> Do I need to replace the set of 8 springs or is there another problem?
>
> Thanks,
> John Spaur
> '62 BT7
> _______________________________________________
> Healeys at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/magnuskarlsson at bornet.net
|