John - thanks for posting the articles and photos. Rich, as always, a great
job of documentation and of sharing your commentary and photos.
It appears that the paint on the hood bows is a slighty different shade of
gray on the two cars. Am I mistaken? but if it is the same? what is the
source?
Also Rich would you happen to have the same type of documentation for the
Longbridge hood and hood bow setup? I am currently reviewing what is presented
for the Longbridge in the 2011 Concours Guide and my Longbridge hood, bows and
webbing are not consistent with the Guide. Do you think there could be
possible that several series exist for the Longbridge , as is documented for
the BN1
Thank you for your assistance and insight - jim lesher
> From: ahbn6 at verizon.net
> To: richchrysler at quickclic.net; stephen.j.cuss at btinternet.com;
healeys at autox.team.net
> Date: Thu, 4 Aug 2011 17:49:59 -0400
> Subject: Re: [Healeys] BN1 Hood configuration
>
> Posted on the Body section of the Technical page.
>
> John Sims, BN6
> Aberdeen, NJ
>
> http://www.healey6.com
>
>
> -----Original Message-----
> From: Rich Chrysler [mailto:richchrysler at quickclic.net]
> Sent: Thursday, August 04, 2011 2:42 PM
> To: 'STEPHEN CUSS'; healeys at autox.team.net
> Cc: ahbn6 at verizon.net
> Subject: RE: [Healeys] BN1 Hood configuration
>
> Stephen et al,
>
> The 3rd series of hood bows on the Hundred that featured the elongated
> obtuse angle slotted mounting arm for better stowage when folded, also
> featured a pair of small holes per each side on the rear most hood iron
that
> accepted a pair of screws that entered from inside the car, piercing to
> anchor the webbing straps.
>
> Please note that the 3 mounting holes per side of the car did not change
> position throughout the production of the Hundred.
>
> Listers, this is also being forwarded to John Sims for posting.
>
> Rich
>
> -----Original Message-----
> From: healeys-bounces at autox.team.net
[mailto:healeys-bounces at autox.team.net]
> On Behalf Of STEPHEN CUSS
> Sent: 2011-08-04 12:51
> To: healeys at autox.team.net
> Subject: [Healeys] BN1 Hood configuration
>
> Hi everyone, just putting finishing touches to re-build, but am not clear
> how hood frame should work as mine appears bent in several places has
anyone
> got some good photos of hood in both down and up positions. I need this as
I
> need to mount my seat belts and do not want to find I have put the mounts
in
> the wrong place. Thanks for all the help with this matter. Stephen
> _______________________________________________
> _______________________________________________
> Healeys at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/cleona44 at hotmail.com
|