I installed a red rubber type valve cover gasket on my 66. I had bought
two, one of which I put on the 64 which has a AL cover, no leaks. On
the 66 original valve cover, I stupidly didn't check it out before
driving off on a day trip. Halfway we suddenly got an windscreen full
of oil. Back at my shop, I discovered that any warping of the cover
created a gap that the gasket would not fill. But, it was fixable, by
setting the cover with gasket attached on a flat surface and tapping the
edge down carefully with a rubber hammer, checking with a feeler gauge
around the bottom, till there was no gap anywhere. Now there are no leaks.
John
64/66 BJ8s
On 8/15/2011 9:02 PM, S and T Miller wrote:
> Anyone have any experience (and do they make them for 6 cyl Healeys?) with the
> upgraded valve cover gaskets and side tappet cover gaskets?
>
> The Millers
> "British Car Nuts"
>
> 1957 Austin Healey 100-6 BN4 35299
>
> 1959 Austin Healey 100-6 BN4 77219
>
> 1964 MGB 40841
>
> 1960 Austin Healey Bugeye Sprite AN5 34351
>
> "Always drive them, but remember each drive in an antique car is a test
> drive."
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|