Magnus,
Where was this video when I tore my BN-2 tranny apart 20 years ago??
I collected any and all articles I could before diving in.
It really went quite well and was trouble free for about ten years.
Then the syncros got worn and made down shifting less fun.
A couple of years ago, I took it out again and put some high end syncros in
that are supposed
To last longer. That, along with the BJ-8 clutch I installed, should have
made life good again.
Unfortunately, I still get a grind if downshifting too quickly. Do you think
that could
Be attributed to the MT-90 that I'm using instead of 30 wt non-detergent?
Maybe it's making
Things a little too slippery for things to grab?
What's your opinion?
The video is top notch and may give people the confidence to give it a go.
You do make it look easy!
Bob Bender
> In a message dated 7/19/2011 4:33:03 P.M. Pacific Daylight Time,
> magnuskarlsson at bornet.net writes:
>
> Hi everybody,
>
> I have just published a newly made video covering the dismantling and
> assembly of an Austin Healey gearbox.
>
> You will find it on the following page in my website:
> http://www.concourshealeys.com/videos/
>
> It is the video on top of the page.
>
> I would be glad to receive any feedback, since I4m very curious
> wether it will be appreciated or not. If the response is positive I
> plan on making and publishing other videos similar to this one.
>
> Magnus Karlsson
|