When I removed mine to replace the stator tube, I left the connectors in
place. If I remember correctly, I fished the harness through the tube by
taping the end to a length of solid copper wire. It took a couple of tries
to get a taped connection which was strong enough not to let go in the
middle of the threading process, but not so bulky that it jammed inside of
the tube.
HTH,
Peter Schauss
1963 BJ7
1980 MGB
> -----Original Message-----
> From: healeys-bounces@autox.team.net [mailto:healeys-
> bounces@autox.team.net] On Behalf Of healeymanjim@hansencc.net
> Sent: Friday, July 08, 2011 10:19 PM
> To: healeys@autox.team.net
> Subject: [Healeys] trafficator
>
> i never cut any wires. i always take my soldering gun and heat the
> connectors until they separate from the wires, then tape the wires
> together at the end. resolder after pulling wires back through the stator
> tube. hjim
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|