I have found an alternative to plastic bags for the small bits is egg
cartons. I label each carton alphabetically and each egg cup numerically,
i.e. A-1, A-2, etc. I write down each step as I go along and note the
carton and cup numbers on the notes where fasteners or small parts are
involved. I also note what wrench (excuse me, spanner) I used and its size.
As they say, "Assembly is the reverse of disassembly". My notes assure that
I get everything back in the correct order and don't have to waste time
hunting for the correct tool. Rarely have parts left over. ;-)
(The Other) Len
Vacaville, CA, USA
1967 AH 3000 MkIII, HBJ8L39031
> ----- Original Message -----
> From: "Bob Spidell" <bspidell@comcast.net>
> To: "John Sims" <ahbn6@verizon.net>
> Cc: <healeys@autox.team.net>; <michael.bowie@fivepointsix.com>
> Sent: Saturday, July 02, 2011 4:57 PM
> Subject: Re: [Healeys] 54 BN1 Barn Car
>
>
>> You probably can do this for $10-15K, depending on how much you spend on
>> painting and engine work.
>>
>> Be sure to bag and label all nuts and bolts. We didn't do this on our
>> 100M resto--but we did try to keep them 'organized'--and we waste a lot
>> of time trying to figure out what bolts go where (esp. on a 100, which
>> has a lot of BSF and some Whitworth, esp. on the engine).
>>
>> Bob
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|