I suggest removing the head before rotating. This takes a considerable
amount of weight off the unit. Even then its not a bad idea to have an
assistant to help in the rotation operation. There are so many different
units available online and at parts stores. I would suggest 1000 lb unit
capacity is a good standard. And the balance of the unit after the engine
is hanging is important. Our straight six eng. are pretty long compared to
even some standard 8 cyl. of today.
Hope you shopped around.
Take it back if you don't feel safe and tell them what the problem is.
They can probably get you one that works better.
Some of this is trial and error unfortunately.
FYI, my main problem with my unit was that the damn bolt tubes on the
engine carriage weren't long enough to clear
the crank shaft pulley. And of course I wasn't aware of this until I got
the engine in situ , hanging on the stand and went to
turn the crank and Damn-it. No go. I had to set the engine down and shim
up the the bolt tubes with about 7 washers on each tube.
That was fun.. Like I said , trial and error.
Mark
----- Original Message -----
From: <fogbro1@comcast.net>
To: "Healey List" <healeys@autox.team.net>
Sent: Wednesday, June 15, 2011 10:30 AM
Subject: [Healeys] Engine Stands Again
> List,
>
>
>
> Well, I did purchase a 4 wheel engine stand, but, having got it home and
> having mounted the 6 cylinder lump, I'm not at all satisfied with my
> purchase for the following reasons:
>
>
>
> 1. With the engine upright and sitting so high, it still appears unsafe to
> use as a rebuild platform.
>
> 2. The engine cannot be rotated. The overhung load is so great that, even
> with the clamping bolt loose, the tube-within-tube mounting point binds. I
> had to use the assist of a chain hoist to be able to rotate the engine.
>
> 3. The wheels on the engine stand are too small in diameter, making it
> difficult, if not dangerous, to move over even the smallest irregularity
> or groove in the concrete.
>
>
>
> All that said, have any of you found a stand that is stable with the
> engine upright, moves about a smooth floor easily, and allows rotation of
> the engine?
>
>
>
> Or must this hunk of iron be dealt with in a different manner?
>
>
>
> Right now the stand is providing a storage point off the floor. That's
> all.
>
>
>
> TIA,
>
>
>
> Ed Woods
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/lapierrem@sbcglobal.net
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|