On my BJ8 they are--like the shock bolts, bumper bracket bolts and others--3/8"
fine (24TPI) SAE. IIRC, a 9/16" wrench
or socket will fit them.
I'd go with the inserts (same size--3/8" fine). If you tap oversize you'll
probably have to drill (oversize) the holes
in the slave cylinder. Not only will this somewhat weaken the parts but you'll
eventually strip them out again anyway.
3/8" inserts are common, and the taps come with the kit, but the drill bit
you'll need is an oddball (like a 25/64" or
something, don't recall for sure).
A 3/8" 24TPI insert kit will serve you well over time. Put red Locktite on the
outside of the inserts. I always use a
hardened flatwasher and blue Locktite to fasten aluminum/alloy
parts--lockwashers dig into the Al and lose tension over
time (they also gouge the metal pretty bad).
Bob
On 6/2/2011 7:43 AM, Fred Wescoe wrote:
> Gang,
>
> Can anyone tell what size of the 2 bolts holding the clutch slave cylinder
> (63 BJ7) in place are? A friend, who lives 65 miles away, has asked me to
> come and help him replace the 2 bolts and rebuild the cylinder. I want to
> go prepared.
>
> Should I tap the holes to a larger size (what size) or should I do an insert
> and if so, what size? I don't think I need to be period correct here.
>
> This will save me jacking up my car and pulling a bolt.
>
> Thanks in advance.
>
> Fred
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|