These instructions have always cornfused me. If the bearing is pressed against
the "... abutment shoulder in the hub
..." there won't be much adjustment possible (unless you have a press strong
enough to compress the hardened steel
bearing race, and distort it). The only way to adjust the 'protrusion' would
be to use differing width spacers. I've
always interpreted this as 'make sure the spacer is at least a slight bit above
the face of the hub.' If it isn't, you
probably have an ill-fitting bearing.
Or am I missing something?
Bob
On 5/31/2011 6:43 AM, BJ8 Healeys wrote:
> The shop manual says: "When re-assembling [the bearing hub] it is essential
> that the outer face of the bearing spacer should protrude from .001 in.
> (.025 mm.) to .004 in. (.1 mm.) beyond the outer face of the hub and the
> paper washer, when the bearing is pressed into position. This ensures that
> the bearing is gripped between the abutment shoulder in the hub and the
> driving flange of the axle shaft."
>
> I achieved this measurement by using two 0.003 front wheel bearing shims
> equally spaced around the flange of the hub housing with the bearing spacer
> on top of the bearing, and the paper gasket in place. Using a metal bar
> spanning across the bearing spacer, I tapped on the bar to press in the
> bearing and spacer until the bar was seated on the shims on each side.
>
> Steve Byers
> HBJ8L/36666
> BJ8 Registry
> Havelock, NC USA
>
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell at comcast.net
*******************************************************************
|