Would like to see some photos,
I still need to bolt down my tranny mounts and drive shaft. New wire harness
this weekend, carbs back in two weeks, then hook up and restart car for
first time in 20 months, when we started this project. Still lots to do,
but a lot has been completed.
Good luck with recovery. Do your exercises
Ira Erbs
DIGS-4 Solutions
Portland, OR
sent from my Droid, please excuse typos and random self corrections because
my phone has It's own ideas about what word I meant to write
On May 27, 2011 12:04 PM, "Thomas Morrione" <tjmorrio@colby.edu> wrote:
> Ira b9 fwiw b9 I put my grommets in after I put on durmat and the
tarpaper.
It
> worked ok in all but two of the cases where I didnB9t cut holes quite large
> enough b9 suggest just eyeball it and see if thereB9s any likelihood that
> youB9ll not be able to put the grommet in without more trimming. I did put
> the couple of balk gromment/plugs in before I put on the duramat. Forgot
> which those were though. Have just had knee replacement last week and am
> laid up or would go look further.
>
> Have enjoyed your chronicle of rebuild b9 am about to put in redone
> engine/trans/od this summer and move my project along/
>
> Best,
> Tom
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|