I can second this recommendation, as I've been using their products for
the last 20 years. They are very helpful on the phone as well.
John
64/66 BJ8s
On 4/6/2011 10:55 AM, DANIEL WILLS wrote:
> I suggest to the initial questioner to Google TP Products,Canfield,
> Ohio. They sell a wide range of abrasives and sand blasting
> equipment. The site has a description of the cutting quality of each
> type. The 60 grit aluminum oxide really gets after rust and stays
> shaper longer, the longest lasting although finer, 80 I think, is
> carborundum(sp?)
> I didn't have much luck with a pressure blaster , the valve kept
> clogging even with a bigger diameter. I think the siphon feed is
> better. In either case one has to keep the sand dry or it will carve
> out a small cave around the pick up tube. The air must be dry also or
> it ice up in the head. Use the carbide nozzles. Since it is an
> abrasive the oxide will cut into head and any metal pipes that lead to
> it. You have to keep checking.
> Dan
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|