The wire coming out of the harness going over to the fuel pump should
not have a connector in it originally.
David Nock
British Car Specialists
Stockton Ca 95205
209-948-8767
www.britishcarspecialists.com
.
.
On Mar 22, 2011, at 3:45 PM, john spaur wrote:
> I am installing the wiring and noticed that the fuel pump wire is
> too short to reach the pump connection. I have a LHD BT7 with the
> pump on the right side.
>
> The wiring diagram shows an in-line bullet connection that was used
> to extend the wire to reach the pump. My harness was spliced to
> extend the wire (it may have burned at one point because a green
> wire was spliced onto the white wire.
>
> Would and in-line bullet connection be correct for extending the
> wire to reach the pump or should a new harness be supplied with a
> continuous wire of the correct length?
>
> Thank you,
> John
> '62 BT7
> _______________________________________________
> Healeys at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/
> healeydoc at sbcglobal.net
|