John,
I'd make a steel drift with a pilot and use a hydraulic press to
install. But I have a lathe and a press. May have to ream the ID of
the bushing once installed.
Note that the bushing has a top and bottom. The slanted groove doesn't
go all the way to both edges. The edge that doesn't have the groove is
the bottom and goes next to the oil seal.
Cheers,
Bob Haskell
AHCA 3000 Mk I registrar
http://www.ciahc.org/registry_3000mk1.php
On 03/22/2011 12:05 PM, john spaur wrote:
> Can one install a new bushing with a block of hardwood or is this
> something that I should have a machine shop do? The old bushing has been
> removed.
>
> Thank you,
> John Spaur
> '62 BT7
> _______________________________________________
> Healeys at autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/rchaskell at earthlink.net
|