I would weep thin CA glue (instant glue) into the cracks with a very small
applicator like the tip of a tooth pick. I would fill the hole with a black
epoxy. If possible hold a small piece of wax paper (slightly larger than the
hole) over the outside of the hole with a larger piece of tape. fill the hole
with epoxy from the back side. When everything is set up you can sand the
outside lightly to get a smooth surface with progressively finer sand paper
just like leveling paint. It should be almost invisible.
Gary Hodson
-----Original Message-----
From: john spaur <jmsdarch at sbcglobal.net>
To: healeys at autox.team.net
Sent: Tue, Mar 1, 2011 11:32 am
Subject: [Healeys] Bakelite repair
I have a small (3/8") hole in my blower motor casing with some hairline cracks
radiating from it. I am thinking of using woven fiberglass inside the case
with urethane. .
Is urethane compatible with fiberglass?
How about JB Weld and fiberglass?
Any repair suggestions?
Thank you,
John Spaur
'62 BT7
_______________________________________________
Healeys at autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/warthodson at aol.com
|