I would like to powder coat the steering box and column. However, the
column is soldered to the steering box. The powder that I have been
using curs @ 400 degrees F which may be very close to or over the
melt point of the solder.
Have people experienced a problem with the column separating from the
box? Does anyone know the melting point of the solder that was used?
Any suggestions or comments?
Thank you,
John Spaur
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|