They are all blind holes. A tip - when you install the studs, do not torque
them first as the factory manual suggests. Tighten all of the studs only
finger tight. When you torque the nuts, it will torque both the nuts and the
studs to the proper torque and it is a much better procedure.
Richard Mayor
BN7L-466 Vintage Racer
Portland, Oregon
> From: dirk.e.maier@t-online.de
> To: healeys@autox.team.net
> Date: Fri, 31 Dec 2010 11:54:47 +0100
> Subject: [Healeys] 3000 Engine Block
>
> Hey listers,
>
>
>
> does someone can tell me if all holes for the cylinder head stud bolts in
> the 3000 engine block are blind holes?
>
>
>
>
>
> Kind regards and a happy new year,
>
>
>
>
>
> Dirk
>
>
>
> Siegburg, Germany
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/mayorrichard@hotmail.com
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|