It fit ok before paint. Weird
Ira Erbs
Digs 4 Solutions
Computer Consultants
Portland, OR
On Dec 6, 2010 5:37 AM, "S and T Miller" <stmiller96@hotmail.com> wrote:
>
> If the car has already been painted then you have a difficult task.
Adjustments/ test fits should be made during bodywork. The seal will
probably just make the miss fit even worse. If it isn't too bad then you
might just have to live with it. Most boot lids on Healeys have a fit that
is much less then perfect. Shifting the holes a bit can give you some side
to side fit. Being high in the middle sounds like bodywork.
>
> The Millers
> "British Car Nuts"
>
> 1957 Austin Healey 100-6 BN4 35299
>
> 1959 Austin Healey 100-6 BN4 77219
>
> 1964 MGB 40841
>
> 1960 Austin Healey Bugeye Sprite AN5 34351
>
> "Always drive them, but remember each drive in an antique car is a test
drive."
>
>
> Message: 4
> Date: Sun, 5 Dec 2010 17:48:08 -0800
> From: I Erbs <eyera3@gmail.com>
> Subject: [Healeys] adjusting boot lid
> To: healey help <healeys@autox.team.net>
> Message-ID:
> <AANLkTimehmLRXM153O8L+zbB=ZhUa27FeRb4y3JgERia@mail.gmail.com>
> Content-Type: text/plain; charset="us-ascii"
>
> We are fitting the boot lid on my BT7. It seems to be sitting a bit high
> between the hinges, and we have not yet installed the seal. Is there any
way
> to adjust the fit? It also seems to need movement left and right to center
> it.
> Thanks again,
>
> All four fenders and beads have been fitted. Engine compartment detailing
> continues. Running lights installed, and we are just about ready to
install
> armacord in the boot.
>
> --
> Ira Erbs
> DIGS-4 SOLUTIONS
> IT CONSULTANTS
> Portland, OR
> _______ Austin Healey 3000 _______
> (______ \____1960 BT7____/_______)
> (_________________________)
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|