The shallower side which has a more squared up edge goes to the outside
perimeter of the lid, with the wider angle toward the inside. When gluing
into place, make sure there is no pull exerted on the corner curves or it
will pull away later on.
Rich
--------------------------------------------------
From: "Josi Vicente Vargas" <jvvmusme@yahoo.com>
Sent: Thursday, September 30, 2010 4:19 PM
To: <healeys@autox.team.net>
Subject: [Healeys] BN2 Trunk Seal
> The BN2 trunk seal has a specific shape. On one side it has a shallow
> figure
> and
> on the other side it looks like a piramid. How should I glue the seal ??
> Thanks,
> Jose
> Josi Vicente Vargas
> Musmi
>
>
> Tel. (571) 321 3740
> Cel. (57) 311
> 288 3401
> Skype: jovivago
>
>
> www.musme.net
>
>
> Bogota, Colombia
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/richchrysler@quickclic.net
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|