What can be used is a thin highly polished stainless steel plate
fitted to the the floor between floor and heat source (engine, gearbox,
exhaust) on small rubber mounts/silent blocks with threaded holes both
sides and using small screws or bolts. Shape the plate following the
floor if necessary.
If you do not want to dril holes you may even try to fit the plate to
the floor with a few large blobs of PU sealant and keep it in place for
a day. Make sure everything has been cleaned very well with white spirit
and alcohol before applying the sealant. Be quick, you only have a
minute or so before the sealant starts to form a skin and does not stick
anymore. It should be heat resistant enough.
Kees Oudesluijs
NL
[demime 1.01d removed an attachment of type text/x-vcard which had a name of
coudesluijs.vcf]
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|