The shroud attached on the rear side of the upper bolt on the lower
radiator brackets. The you will need to drill a hole in the original
shroud close to the edge approx 3/8 to 1/2 from the bottom. Then on
the drivers side sometimes they are close to the fan at the bottom
depending on the condition of your motor mounts. If this is the case
then after attaching the shroud at the top an bottom you will need to
push in on the shroud to flatten the curve a little and then tighten
the bottom bolt on the drivers side. This will then give more
clearance at the bottom edge.
David Nock
British Car Specialists
Stockton Ca
209-948-8767
www.britishcarspecialis.com
On Aug 21, 2010, at 12:30 PM, Joe Selgrath wrote:
> I received a fan shroud from BCS, but I'm not sure how the fan
> shroud is installed. I trial fitted the shroud, but I'm not sure
> how much gap to maintain between the fan and the shroud. Does
> anyone have photos of the installation they can send? Or a
> description of how they installed the fan? I am using the BCS flex
> fan.
>
> Thanks
>
> Joe (BN7)
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/
> healeydoc@verizon.net
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|