John,
You probably got no replies because no one has tried this. If there's
no set screw, it's probably--there's that word again--an interference
fit. Frankly, I doubt you can get it off and back on without messing
something up--I think you'd have to clamp the shaft in a vice and
somehow pry the cam off, but you'd probably mess up the case.
bs
john spaur wrote:
> This is a repeat of my post last week; no responses so I am trying again.
>
> I want to zinc plate the housing.
>
> How is the cam removed from the shaft, is it a press fit, can it be
> removed fairly easily; if so how?
>
> TIA
> John Spaur
> '62 BT7
> _______________________________________________
>
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|