Ken,
It will need to be cut to about 4-5 inches length. Also a 12 point not a 6
point.
Keith
---- "Freese wrote:
> One should check which wrench they want to sacrifice before doing the deed.
> The swing is pretty limited as I recall. One might need a C type curved
> wrench.
> Ken Freese
> 65 BJ8
>
> -----Original Message-----
> From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
> On Behalf Of Bob Spidell
> Sent: Tuesday, August 10, 2010 2:55 PM
> To: Don Day
> Cc: healeys@autox.team.net
> Subject: Re: [Healeys] carb oil
>
> Or buy a cheap 5/8" socket and cut a slot in it with a cutoff tool.
>
> bs
>
> --------------------------------
> Bob Spidell - San Jose, CA
>
>
> I bought a quart of 30wt,they didn't have 20wt,I will bring it back,then look
> for a place that sells 20wt.In the mean time I used 3@1.I am ready to start
> the motor up,I put anti-freeze in and I found that I didn't tighten up the
> temperature sending probe that goes into the block.5/8 craws foot needed.I
> wonder if they sell a 5/8 oxygen sensor socket?That would work.
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/kendall.freese@aerojet.com
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
>http://autox.team.net/mailman/options/healeys/pennell@cox.net
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|