To: | cnaarndt@gmail.com, tadeusz.malkiewicz@plusnet.pl |
---|---|
Subject: | Re: [Healeys] nut type for Smiths heater assembly for BN2 |
From: | "warthodson@aol.com" <warthodson@aol.com> |
Date: | Sun, 08 Aug 2010 20:05:27 -0400 |
Also, the throttle linkage ball joint nuts are BA. Gary Hodson *BA (British Association)* found primarily in the Smith's gauges, fuel umps/sending units, and wiper motors. Be careful however as No. 2BA is very lose to a standard UNF/SAE Fine 10/32 thread and a 10/32 nut will thread nto 2BA stud or screw and vice versa. However a 10/32 screw will not hread into a deep 2BA tapped hole. = _______________________________________________ Healeys@autox.team.net Donate: http://www.team.net/donate.html Suggested annual donation $12.75 Archive: http://www.team.net/archive Forums: http://www.team.net/forums |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [Healeys] 65BJ8 -- Driver's Side Rear Shock,, Greg Mandas |
---|---|
Next by Date: | [Healeys] Cobra Kit Car Project - $2500 built on Healey 100 frame, I Erbs |
Previous by Thread: | Re: [Healeys] nut type for Smiths heater assembly for BN2, Curt/Nancy Arndt |
Next by Thread: | Re: [Healeys] nut type for Smiths heater assembly for BN2, Tadeusz Malkiewicz |
Indexes: | [Date] [Thread] [Top] [All Lists] |