Hello Bob, Josef,
What end are you looking from?
When I look at the engine from the gearbox side, I have holes milled at 1 &
7 o'clock.
Best, tadek
-----Original Message-----
From: Bob Spidell [mailto:bspidell@comcast.net]
Sent: Wednesday, August 04, 2010 5:22 PM
To: Josef.Eckert@t-systems.com
Cc: tadeusz.malkiewicz@plusnet.pl; Healeys@autox.team.net
Subject: Re: [Healeys] Gearbox to engine dowel bolts position?
On our BN2, there are milled recesses for bolt heads at the 1 and 7
o'clock position--I figured the dowel bolts went there.
If not, why do only these two positions have milled recesses?
bs
Josef.Eckert@t-systems.com wrote:
> Hello Tadek,
> They go at 5 and 11 o clock position.
>
> Josef Eckert
> Konigswinter/Germany
>
> Betreff: [Healeys] Gearbox to engine dowel bolts position?
>
> Hello,
>
> There are 2 dowel bolts to mate the gearbox to the engine - where do they
> go??..
>
> Many thanks,
>
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|