Hi Keith
I've had a similar problem on the Ward Spl motor - first thought it was the
tacho drive (mine's electronic so this was "open") - put cap on that, no
change. Then went to sideplate - replaced gasket and used sealant - no
change. Cleaned up block thoroughly & watched for dribble of oil - appears
to be coming from large plug at bottom of block casting for oil pump/tacho
drive (shown as item 28 on p D/21 of workshop manual, and item 97 on p 1.13
of SC Parts catalogue - plug- distributor & oil pump spindle bore). This has
a sealing ring under it. I haven't tried doing anything with this yet as
it's hard to get at with engine in car. I do get a few drips from the
breather pipe too.
Cheers
Peter
--------------------------------------------------
From: "Keith Bailey" <keithbailey5@bigpond.com>
Sent: Wednesday, August 04, 2010 11:40 AM
To: <Healeys@autox.team.net>
Subject: [Healeys] Oil Leak
> I have an oil leak on my BN1 which appears to be over the Right hand
> chassis
> rail under the cold box
> It could be from oil getting into cold box through the rocker cover
> breather
> pipe it as been suggested
> my rocker bushes could be worn but when they were assembled there did not
> appear to be any excessive
> wear.The tacko drive is leak free No oil is running down the crank case
> from
> rocker cover.
> any other suggestion would be appreciated
> Regards Keith
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/greylinn@ozemail.com.au
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|