Hi List,
I'm about ready to turn the power onto my new wiring harness.I have
gone around and double checked all my connections.All the wires are hooked up
to where they should go,hopefully.I was thinking of leaving my new fuel pump
disconnected,other than that should I just turn the switch on and hope for the
best or is there a sequence of pluging stuff in and look for smoke?I have a new
voltage regulator,and new relays everywhere.
I would love to just turn the switch on ,listen for the fuel pump to stop
clicking,turn the key and the motor will start right up.Anyone had any
experience with this step?
THanks Don
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|