Hi Ron,
It's the 4 1/2" pulley, 3/8" wide that should be on your Mk 2. The larger
pulley was on the earlier 100/Six engines.
Rich
--------------------------------------------------
From: "Ron Mitchell" <healeyron@yahoo.com>
Sent: Monday, July 26, 2010 8:14 AM
To: <kbeck100@rcn.com>
Cc: "Austin Healey List" <healeys@autox.team.net>
Subject: Re: [Healeys] [Healeys} still too hot
> Thanks Ken,
>
> That is why I am rebuilding the Distributor today to make sure
> the pivots aren't
> too loose which could be preventing the specified
> centrifical advance of 35
> degrees.
>
> Any idea on what the Water Pump Pulley
> dia should be for a 1962 MkII 3000?
>
> See you at Encounter I hope.
> Ron
> ________________________________
> From: ah <kbeck100@rcn.com>
> To: Ron Mitchell
> <healeyron@yahoo.com>; healeys@autox.team.net
> Sent: Mon, July 26, 2010 7:21:55
> AM
> Subject: Re: [Healeys] still too hot...
>
> Ron: Check your timing at total
> advance. Run the engine to 2500 or so and
> see what your timing is. Total
> should be around 32 degrees adv. Above 36 is
> pushing it
>
> Ken BEck
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/richchrysler@quickclic.net
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|