Hi Mark,
The front bumper brackets on your 6 cylinder Healey will have (when viewed
straight down from above) the straight brackets on the inboard side until
they come to the bumper mounting bosses, where they turn roughly 90 degrees
inboard. The angled brackets come straight out just so far and then do a
single outboard angle 'till it gets out to the bumper, then a single angle
outboard so it can lie flat against the bumper mounting bosses. There should
be no curving of the brackets in any way, again, when viewed looking
straight down from above.
Rich Chrysler
--------------------------------------------------
From: "Mark LaPierre" <lapierrem@sbcglobal.net>
Sent: Thursday, June 10, 2010 10:46 PM
To: <healeys@Autox.Team.Net>
Subject: [Healeys] Front Bumper Brackets
> Which way do the front bumper brackets go? The brackets are 2 flat steel
> bars
> welded
> together. One bar is straighter than the other. Does the straighter
> bar go
> to the inside or
> outside of the car?
>
> The holes are not lining up either way for me right now so I will have to
> enlarge the bracket holes
> but I would at least like to get them lined up on the right side to start
> with.
>
> Thanks Guys, Mark
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/richchrysler@quickclic.net
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|