If the car has overheated you have a big chance that you have to shave
the head again. Also check for cracks, as I think these heads are prone
to cracks. Always fit a cilinder head dry on these cast iron lumps.
Only in some applications in mainly alloy block engines with separate
steel liners some sealant is used between the outer edge of the
block/gasket/head.
Kees Oudesluijs
S and T Miller wrote:
> I rebuilt a guys 100-4 engine a few years ago, where we converted it to "M"
> specs and .030 over. He over heated it at least once (I didn't do anything to
> his rad.). He now has a head gasket coolant leak (3,000 plus miles) on the
> right side of the motor. Is there any recommendations for a replacement head
> gasket or head gasket sealant? I have always been one to not use any sealant
> on head gaskets.
>
> Thanks, Shawn
>
> The Millers
> "British Car Nuts"
>
> 1957 Austin Healey 100-6 BN4 35299
>
> 1959 Austin Healey 100-6 BN4 77219
>
> 1964 MGB 40841
>
> 1960 Austin Healey Bugeye Sprite AN5 34351
>
> "Always drive them, but remember each drive in an antique car is a test
> drive."
>
>
>
>
> _________________________________________________________________
> Hotmail is redefining busy with tools for the New Busy. Get more from your
> inbox.
> http://www.windowslive.com/campaign/thenewbusy?ocid=PID28326::T:WLMTAGL:ON:WL
> :en-US:WM_HMP:042010_2
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
>http://autox.team.net/mailman/options/healeys/coudesluijs@chello.nl
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|