Thomas,
The wiring harness came down to mount on the front face of the front cross
member and was not protected any further than the outer cloth loom and the
covering of each individual wire. Of course the wire ends went through the
rubber seals and into the horn bodies.
Rich
--------------------------------------------------
From: "T+ B Willig" <willig@wtnet.de>
Sent: Saturday, May 22, 2010 12:45 PM
To: <healeys@autox.team.net>
Subject: [Healeys] BN2 horn wire insulation
> I just fitted the horns to my BN2 and I noticed that the wires / bullet
> connectors are fixed, unprotected, to the front crossmember. Was it like
> this originally or were some kind of protection fitted by the factory?
>
> Thomas Willig
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/richchrysler@quickclic.net
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|