Coming to Dowel Bolts,
is there any supplier for these bolts? Where can I get a set for a 3000 MK2,
MK3 or 100?
Many thanks.
Josef Eckert
Konigswinter/Germany
-----Urspr|ngliche Nachricht-----
Von: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net] Im
Auftrag von Earl Kagna
Gesendet: Donnerstag, 20. Mai 2010 04:28
An: Alan Seigrist; I Erbs; Healey List
Betreff: Re: [Healeys] template for BJ8 clutch
Alan / Ira:
Sorry to disagree - the BJ8 clutch uses a larger mounting bolt than the
earlier one, and 3 dowels instead of 2. The fix is the same - take the
flywheel and the clutch cover to a good machine shop - they'll figure it out
for you.
Done this a few times.
Earl Kagna
Victoria, B.C.
BT7 tri-carb
BJ8
----- Original Message -----
From: "Alan Seigrist" <healey.nut@gmail.com>
To: "I Erbs" <eyera3@gmail.com>; "healey help" <healeys@autox.team.net>
Sent: Wednesday, May 19, 2010 3:19 PM
Subject: Re: [Healeys] template for BJ8 clutch
The bolt holes will be the same, only the pegs are different.
Just purchase the BJ8 clutch cover and take it to your Machine shop
and let them balance and do the peg work.
No need for a template....
On 5/20/10, I Erbs <eyera3@gmail.com> wrote:
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|