Keith,
There are 3 studs that protrude from the back face (toward the front of the
car) of the heater/blower assembly. The two upper studs pass through a
single vertical plate that sits up from the scuttle box on the centre line
of the car. These will be fastened by running flat washers, lock washers and
1/4" nuts onto the studs. The third stud will pass through a single hole and
into the scuttle box. The flat, lock, and nut will be attached by installing
them in through the single large hole in the bulkhead, again on centre line
of the car, and located right behind the engine. When these are installed, a
blanking plug fills the access hole in the bulkhead.
The 3 mounting point are visible on this freshly prepared chassis bulkhead.
Rich
--------------------------------------------------
From: "Keith Taylor" <krtaylor@exemail.com.au>
Sent: Monday, May 10, 2010 6:21 PM
To: <healeys@autox.team.net>
Subject: [Healeys] BN2 Heater fixing
> Looking for fixing setup for a BN2 heater. OZ cars really came with a
> heater
> ,
> as a kid "who cared" now in my twilight years I am looking to add this
> comfort
> I have the heater but cannot fathom how it is mounted maybe this heater is
> incomplete (sans brackets) ! Anyone from more frigid parts able to photo
> the
> fixing setup ? My research has drawn a blank.
>
> Keith Taylor
> WAMBERAL OZ
> BN1.........If I ever finish them
> BN2................ " ..............
> 100M.......Getting close
[demime 1.01d removed an attachment of type image/jpeg which had a name of
apr10 037.jpg]
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|