Kees -
Would grease in the bronze ball armature bearing be correct, or some sort of
oil?
Alan
'52 A90
'53 BN1
'59 Jag Mk IX
'64 BJ8
On Sun, May 9, 2010 at 4:13 PM, Oudesluys <coudesluijs@chello.nl> wrote:
> Alan,
> Remove the old sticky stuff, clean thoroughly with white spirits or similar
> and repack with grease. You can use Lithium grease but I have used Molykote
> grease in the past. Do not pack it to the brim, use it reasonably sparingly.
> If you have everything apart, turn the gears for the wiper spindles
> 180degrees to compensate for wear. This will give you a lot less play in the
> wipers. Use oil to lubricate the spindles, grease for the cable/gear.
> Kees Oudesluijs
> NL
>
>
> Alan Seigrist wrote:
>
>> All -
>>
>> I have my old Lucas CRT wiper motor apart and am wondering if packing the
>> gear case / brass armature bearing / cable with white lithium wheel
>> bearing
>> grease is ok?
>>
>> I note the 59 yr. old bearing grease in the case is still softish, but
>> very
>> sticky, was wondering it that's the way this stuff is supposed to be? If
>> not I'll clear it all out, the motor turns a bit slow and I think it's
>> because of the sticky grease.
>>
>> Thoughts?
>>
>> Alan
>>
>> '52 A90
>> '53 BN1
>> '59 Jag Mk IX
>> '64 BJ8
>> _______________________________________________
>> Healeys@autox.team.net
>> Donate: http://www.team.net/donate.html
>> Suggested annual donation $12.75
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe/Manage:
>> http://autox.team.net/mailman/options/healeys/coudesluijs@chello.nl
>> ------------------------------------------------------------------------
>>
>>
>> Geen virus gevonden in het binnenkomende-bericht.
>> Gecontroleerd door AVG - www.avg.com Versie: 9.0.819 / Virusdatabase:
>> 271.1.1/2862 - datum van uitgifte: 05/08/10 20:26:00
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|