I give up. What's a 'bitza?'
bs
Ray Juncal wrote:
> I have been following the thread on 100-M carbs. I happen to be in the
> process of rebuilding two pairs of H-6s on 100-M manifolds. I have had both
> sets since the early seventies I don't think anyone was reproducing "M"
> manifolds at that time so I think they are legit. The carbs came with the
> manifolds so the chances are good they may be correct also. The carbs have
> the "AUC 6040 X" number but I cant see any other hand etched numbers. On my
> H-4s there is a small plinth with hand etched "6000"numbers but the H-6s have
> no such dedicated number location. Exactly where should I look for the hand
> etched numbers? The bodies of the carbs I have only have one of the
> mounting bosses machined off. All four bodies have three bosses. According
> to previous posts, three bosses should have been removed leaving only one. Is
> that correct. If these carbs are not 100-Ms what could they be? maybe from a
> 100-6 or 3000? I have tried to find
> photos of a 100-M engine showing the carbs in the books I have without much
> luck. Not enough detail. My cars are kind of bitzas so the info is more
> interest than necessity. Anyone have anything to add?Ray Juncal
>
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|