Thanks - I will take another look.
Al Fuller
al at bighealey dot org
'62 BT-7
'65 BJ-8
'85 Rx-7
From: I Erbs [mailto:eyera3@gmail.com]
Sent: Tuesday, April 27, 2010 4:03 PM
To: Al Fuller
Cc: Healeys@autox.team.net
Subject: Re: [Healeys] Shock oil - wheel position
I think you need to burp the pressure out of the shocks, and then fill them
up. Opening the fill screw releases the pressure on the oil.
Other will confirm or deny this rumor :)
cheers.
On Tue, Apr 27, 2010 at 12:42 PM, Al Fuller <al@bighealey.org> wrote:
All:
I went in to check the oil level on a rear shock on my '62 BT-7 which
appeared to be leaking (oil around the shock housing). Upon cleaning then
pulling the fill plug, oil flowed out, as if it was over-full. Since I
doubt it was/is still over full here is the question before I go check the
other three shocks:
Does it make any difference in the oil level whether the wheel assembly was
supported or hanging (with the jack stands under the frame instead of under
the wheels)? In other words, is it possible for it to appear full/over full
by virtue of where the lever arm is in its travel?
Thanks in advance.
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|