Rich,
Woolies in the UK sells felt that might match said padding. Would you say
that this padding is 3/8" or 1/4" thick?
Regards
Thomas
-----Urspr|ngliche Nachricht-----
Von: Rich C [mailto:richchrysler@quickclic.net]
Gesendet: Samstag, 3. April 2010 05:14
An: T+ B Willig; Healeys@autox.team.net
Betreff: Re: [Healeys] Fitting the armrest pad on BN2
Thomas,
I can't help you specifically with the thin jute under padding fitted to the
gearbox cover carpet. However I have seen it in the past and it is very thin
and simply glues in place on the carpet, staying about 2" back from any
edges.
The two forward male Tenax studs are attached to the tunnel carpet and float
in the carpet. (see picture 20031 showing an original BN2 with arm rest
removed) Though they are no doubt not supplied with any kits, the under
sides are similar to the female ones where the threaded stud base will go
down through the carpet and the threaded locking ring will screw on from
below, tightening with the standard Tenax wrench into the two little holes.
Rich
--------------------------------------------------
From: "T+ B Willig" <willig@wtnet.de>
> In the Anderson-Moment book is written on page 52
>
"A jute pad covering about 70 percent of the tunnel was glued to the
> underside of the tunnel carpet". Has anybody taken sketches of the
> outline of this jute pad?
>
Further on it reads: "Tenax snap studs, to which the armrest pad front
> corners were snapped, were fastened to the carpet cover." Is this correct?
> Are the Tenax studs really screwed onto the carpet?
>
Please advise
>
Thomas
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|