I am trying to get the windshield installed permanently.
Whats the secret in getting the windshield to come down enough to get the
holes in the
pillars to line up so I can put the screws in.
Previously I refit the unit as a dry run with the old seal and no dash pad
yet. It fit fine.
Now I have about 3/4 of an inch of the new seal going under the pillars,and
then the pillar rubber
pads and a new dash pad.
1-First off, is the seal suppose to go under the pillar a little?
2-Does it need to be thinned down a little bit so it lays flat.
3-How many elephants does it take to sit on the windshield to push it down?
The dash seems to be a bit of a hindrance too but theres not much I can
alter there.
Any help would be appreciated, Mark
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|